The three-phase separator divides the well products into oil, gas and water, applied to the processing of the higher water content in oil well products, widely used in the production of the high water content in the oil field gathering and transportation within the joint station. The three-phase separator also can be separated from the solid impurities, such as sand, rust, sludge deposition.

①
VOLVO Series Diesel Generator Sets

②
CUMMINS Series Diesel Generator Sets

③
DS Series Diesel Generator Sets

④
DOOSAN Series Diesel Generator Sets

⑤
SCANIA Series Diesel Generator Sets

⑥
DJ Series Diesel Generator Sets

⑦
MTU Series Diesel Generator Sets

We are offering a full range of highly reliable oil-free piston compressors , air cooled or water cooled CNG compressor collect gas from oil wells, gas wells , after gathered, CNG natural gas is transferred through pipes to storage tanks, or to gas station filling cylinder or directly fill car. high pressure 20mpa,25mpa CNG filling compressor ,well head gas compressor ,offshore CNG compressor are usually cooled by air.

Heat exchangers are widely used in shipbuilding, metallurgy, food, machinery, petrochemicals, living area heating, air conditioning, pharmaceuticals, leather, dairy, beverage, wine, waste water, refrigeration and other industries in the heat, concentration, poverty fungus, condensation, evaporation and other processes. The most common examples of heat exchangers in our daily life is automotive radiators, condensers, evaporators, heating radiator and oil cooler.

The surface multiphase PCP is a positive displacement pump mainly composed of a stator and a rotor.

The rod pump can be connected to the lower end of sucker rod on the surface and then lowered into wells integrally through the tubing.

The tubing pump can be run in as follows: pump barrel is run into the setting depth along with the tubing, then connects plunger and the sucker rod, and puts them into the pump barrel. For tubing of same diameter, tubing pumps are always of larger capacity than rod pumps. The tubing pump is simple in structure and applicable for wells which is not deep and of high yield.

ESP cable is divided into round cable and flat cable. The cable consists of conductor, insulating layer, jacket and cable armor. According to the different requirements of power and different condition of oil well, there are different specifications of cable. There are 90℃, 120℃, 150℃, 180℃, 204℃, 232℃ and 250℃ according to temperature rating; there are 3kV and 6kV according to voltage rating. To prevent it from being damaged, we usually use galvanized steel armor, stainless steel armor or monel armor for corrosive medium. All of products are produced and tested complying with national standard GB/ T16750, IEEE or API Recommended Practice.

ESPCP fundamentally eliminates the problem of rod screw pump such as: the rod broke and limited by the deep and deviated wells. It also overcomes the problem that the pump efficiency is low when the pump transports viscosity crude. For ESPCP has no valve body and complex runner, little hydraulic loss, sucks and exhausts medium continually, uneasy to be blocked by sand and gas lock, so the fluid transported by pump has wide range which includes high viscosity, high wax content oil, sand or gas content oil.