High Efficiency Separator

The three-phase separator divides the well products into oil, gas and water, applied to the processing of the higher water content in oil well products, widely used in the production of the high water content in the oil field gathering and transportation within the joint station. The three-phase separator also can be separated from the solid impurities, such as sand, rust, sludge deposition.

①Light and medium crude oil separator processing indicators 

l  The exhaust of crude oil water content ≤ 0.5%;

l  Outlet sewage oily ≤ 300mg / L;

l  Outlet gas liquid content ≤ 0.05g/Nm3

l  High aqueous crude oil by the three-phase separator dehydration enables crude aqueous sewage oily reduced to below 0.5%, less than 300mg / L.

②Medium and heavy crudes efficient gas-water three-phase separator

l  Intermediate crude oil processing indicators

l  The export of crude oil water content ≤ 0.5%;

l  Outlet sewage oily ≤ 300mg / L;

l  The outlet gas fluid volume ≤ 0.05g / Nm3;

l  Indicators of heavy oil and extra-heavy oil processing

l  Dehydration rate: 90 ~ 98%;

l  Diameter ≥ 75 μm sand removal rate of ≥ 95%;

l  The prolapse sewage oily rate 500 ~ 1000mg / L;

l  The device exports of crude oil moisture content of 5 to 15%.

③Heat separator

 The use of equipment is isolated from the gas fuel efficient separation of oil, gas and water sands within the device.  Mainly used in the oil temperature between 20-40 ℃ heavy low viscosity of crude oil and heavy highly viscous crude oil, associated gas, the separation of the mixture of water and sand.

 Proceeding Index

Heavy crude oil imports :15-90% water

Outlet of crude oil moisture content 5-10%

Outlet sewage Oily: ≤ 500mg / L

Export gas liquid content: ≤ 0.1USGa1/MMSCF

Diameter ≥ 75 μm sand removal rate: ≥ 95%

Applied crude index

Applied crude index